REMOVE OIL FILTER, WHILE DRAINING, INSPECT TIRES, ALL FLUIDS, BELTS & WIPERS. INSTALL NEW OIL FILTER, DRAIN PLUG WASHER AND FILL WITH MOTOR OIL. TEMPORARILY RUN ENGINE, INSPECT OIL LEVEL AND INSPECT FOR LEAKS.
FILL OUT FORM NOTE; FRONT STRUTS LEAKING OIL, TIME TO REPLACE ALL THE WAY AROUND. DUE FOR BRAKE FLUSH
DRAIN PAN AND TORQUE CONVERTER, CLEAN TRANSMISSION PAN, INSPECT OLD FILTER AND PAN FOR SIGNS OF MATERIAL. INSTALL NEW FILTER AND PAN GASKET FLUID FILL AND DRIVE OUT FOR PROPER SHIFT. ADJUST IF NECESSARY.
HOOK UP COMPUTER, CHECK FOR CODES FOUND WATER IN BLIND SPOT ASSIST MODULE.
R&R OF REAR BUMPER REQUIRED TO INSPECT AND TEST FURTHER. R&R BUMPER TO INSPECT MODULES. REPLACED, CLEAR CODES, PROGRAM
COULD NOT DUPLICATE INSPECT ENTIRE DRIVE LINE WITH NO ISSUES FOUND POSS MOTOR MOUNTS ARE GETTING LOW BUT LOOK GOOD SO FAR
JEFF M. gave our service a 5 star review on 3/15/2024
COMPLETE A SERVICE INSPECTION INCLUDING OIL AND FILTER CHANGE WITH MOBIL 1 OIL.
REPLACE WIPERS
AIR CLEANER ELEMENT – Remove & Replace – Both
CABIN AIR FILTER – Remove & Replace
DRAIN RADIATOR AND CONNECT HOSE TO FLUSH ENGINE BLOCK AND HEATER CORE OF OLD ANTIFREEZE. INSTALL NEW ANTIFREEZE AND RUN ENGINE TO OPEN THERMOSTAT AND CHECK FOR LEAKS.
R&R MASTER CYLINDER, RESERVOIR, CLEAN OUT, RE-INSTALL AND CHECK FOR GROMMETS LEAKING. FLUSH ALL WHEELS UNTILL CLEAN FLUID EXITS, STARTING AT PASS REAR AND WORKING FORWARD TO DRIVERS FRONT.
SPARK PLUGS – Remove & Replace
LEAKING AT CAM SEAL PLUGS ON LEFT AND RIGHT CYLINDER HEADS AT BACK OF HEADS. REPLACED ALL 3 PLUGS SEALS AND VENT ON RIGHT HEAD.
R&R VAC PUMP, INSTALL NEW WITH O-RING
DRIVE BELT TENSIONER – Remove & Replace
STABILIZER BAR CONTROL LINK – Remove & Replace – [DOES NOT include alignment.]
AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Right,Front Axle – [NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
JULIE W. gave our service a 5 star review on 12/22/2023